Preventive Maintenance

THE BEST TUNE-UP IN TOWN!
Precision Furnace Tune-Up Benefits:
- Lower utility bills
- Extended equipment life
- Fewer repairs, breakdowns and improved system reliability
- Peace of mind
- Increased heating capacity
- Priority service schueduling
Precision Air-Conditioning Tune-Up Benefits:
- Lower utility bills by reducing energy consumption and waste
- Extended equipment life
- Peace of mind
- Fewer repairs and improved system capacity
- Increased cooling capacity and efficiency
Our Exclusive Precision Tune-Up Procedure Includes, As Needed:
Performance Furnace Tune-Up
- Inspect and tighten all electrical connections and terminals
- Remove, clean, and adjust main gas burners
- Remove, clean, and adjust ignition pilot assembly
- Thoroughly brush and vacuum clean the heat exchanger(s) & combustion chambers for cracks, rusting or problem areas
- Vacuum out blower compartment, return airdrop, and surrounding area (No duct cleaning)
- Inspect the flue assembly and test flue gas drafting mechanism
- Test and inspect all furnace safety controls
- Test, record, and adjust gas pressure
- Replace or clean standard air filters
- Clean blower motor, drive mechanism, and fan assembly
- Lubricate all fan motors and all moving parts
- Measure and adjust blower for correct airflow
- Adjust all dampers and set proper blower speed(s)
- Check, test and calibrate thermostat
- Measure and record heating system output
- Inspect and test thermocouple output as well as pilot safety switch
- Measure and record electrical voltage, amperage, and component resistance
- Inspect and test all system transformers, relays, and controls and measure performance
- Repair minor air leaks in plenum and return airdrop
- Perform a complete and thorough carbon monoxide leak test
- Advise customer on other ways to reduce energy consumption, improve safety and enhance comfort.
Performance Air Conditioner Tune-Up
- Clean and thoroughly was condenser coil(s)
- Thoroughly clean or replace standard filters
- Lubricate motor and fan bearings as well as other moving parts as necessary
- Clean and inspect evaporator coil and drain pan when readily accessible
- Clean and inspect condensate drain lines and fittings
- Check, test and calibrate thermostat
- Adjust and thoroughly clean blower motor and fan assembly as needed
- Inspect, tighten, and test all electrical connections. This includes disconnect switch.
- Inspect all cooling system electrical wires, connectors, and terminals
- Test system starting and running capacitors
- Test all controls, switches, relays, transformers, contactors, motors and fans
- Measure starting and running amperes, line voltages, and control voltage
- Test system starting capabilities
- Test system for proper airflow and air delivery
- Monitor refrigerant (Freon) pressures and temperatures with factory specifications
- Adjust Freon metering control device per factory manufacturers recommendations
- Test and measure air condensing system for proper production and capacity
- Monitor fan motors and compressor operating temperatures
- Complete and present full written report